Tessier DUALSKI, Инструкция по эксплуатации и техническому обслуживанию, Страница: 18 / 23

18
Seat
The seat is covered with two types of foam:
1. Foam that is damp-proof glued to the seat and in the backrest.
2. At the bottom of the seat, removable and very comfortable foam which has some
distinct characteristics :
-
it hardens in the cold, but with the heat from the skier’s body it softens and
takes the shape of the skier.
- it can shrink in the seat but will regain its original shape when it is taken off
and placed in a warm environment.
- it is relatively damp-proof but it may be necessary to dry it out.
Seat assembly
- Use the hardware as in the sketch above.
-
Attention , screws that are not the original ones and which are too long could
damage the seats and chairlifts.
- If the seat is not the original TESSIER one, then it is necessary to drill the rear
securing points at a distance of 215 mm from the back of the seat, according to
the above sketch. This is important in order to respect the balance of the Dualski
during gliding and when using the chairlifts.
- Fixation distances: between front holes: 140 mm, between rear holes: 120 mm,
between front and rear holes: 200 mm as indicated on the plan.
When in doubt, don’t hesitate to contact us. The use of a seat which is not a
Tessier seat cancels the warranty.