TESSERA TK-78K0R/KG3+UD, Руководство пользователя

Страница: 102 / 125

6.2.1 "Can not communicate with Emulator..." (F0100 or A0109)
Check Point 1
If you use USB hub, do not use it. (USB hub is not supported)
Check Point 2
Check if the settings of the switch on the kit are correct with referring " 1.3 Installation
of USB Driver ".
Check Point 3
Confirm the USB driver installation with referring to " 1.3.3 Completion of USB Driver
Installation ".
Check Point 4
If above 3 check points are confirmed, close the debugger and disconnect the USB
cable from PC. Re-connect USB cable properly to both the PC and the kit, and then
re-start the debugger.
6.2.2 "Incorrect ID Code." (Ff603)
This error occurs when the security ID stored on microcontroller built-in flash memory is
different from the ID code you entered at the start of debugger.
Security ID entry area at the start of debugger
Check Point 1
Enter correct security ID and click OK on the configuration window.
Check Point 2
If you forgot the security ID, you have to erase the microcontroller built-in flash
memory. Before erasing, check if you actually set the security ID with referring to
"3.4Configuration of Linker Option". Also remember the code you set for the security
ID.
After this, erase the flash memory with referring to "
7.4Erase of flash memory ".
6.2.3 "The on-chip debug function had been disabled in the device."
(F0c79)
This error occurs when the value at address C3H (On-chip debug option byte) in
microcontroller built-in flash memory is incorrect. You need to erase the flash memory.
Check Point 1
Check if you actually set the correct on-chip debug option byte with referring to
"3.4Configuration of Linker Option". If it is not correct, then set correctly.
Check Point 2
Erase the flash memory with referring to " 7.4Erase of flash memory ".
- 102 -