Tiger Shark Operation Instruction Manual
http://tesoro.com/TigerShark_Manual.htm
4 sur 15
21/06/2007 14:32
slack near the searchcoil to permit searchcoil adjustment.
Install the coil connector into its receptacle on the back of the control housing and tighten it fingertight.
Note: Do not use pliers to tighten the coil connector. Do not allow the cable to flop loosely over the
searchcoil. Since the detector is sensitive enough to "see" the tiny wires in
the cable, a floppy cable can
cause false signals as the searchcoil senses the moving wires.
BATTERY INSTALLATION / REPLACEMENT
The Tiger Shark has been equipped with a drop-in battery pack. To install or replace the batteries, make
sure the detector housing is dry, then release the two draw bolts securing the faceplate to the housing.
Gently pull the control panel free being careful not to twist or strain the ribbon cable connecting the
faceplate panel to the printed circuit board. The Tiger Shark takes 8 AA size alkaline batteries. Also,
make certain that you follow the polarity indicators on both the battery
holder as well as the batteries themselves. Then check the polarity of the pack as it goes into the housing.
Look inside the housing for the two spring clips and slide the pack so that the battery pack terminals
meet the spring clips. There is only one correct way to put the battery pack in. If the batteries are put in
wrong, the detector will not work. Replace the faceplate and use the drawbolts to clamp the faceplate
back onto the housing.
Do not rest the unit on the coil connector while clamping the faceplate.
This can cause excess wear and damage to the connector.
Important Note:
Always make sure the instrument is dry before opening.
Water, if allowed to make contact with the circuit board, may damage it.
Always make sure the O-ring is clean and free of dirt or sand. It is
recommended that you wipe the O-ring with a dry cloth and look for
damage and apply a new coat of diver's silicone grease before replacing it.
Failure to maintain the O-ring will result in extensive damage and will not
be covered under warranty.