Tiger Shark Operation Instruction Manual
http://tesoro.com/TigerShark_Manual.htm
10 sur 15
21/06/2007 14:32
responses of your machine. At a later date, you may also build a test garden to test your detector in the
field.
Conclusion
Congratulations, you have just finished the Quickstart for your new Tiger Shark metal detector and in the
process have learned quite a lot about your detector. But experience is the best teacher. I would
recommend that you get out and practice with your detector as much as possible. Any time spent using
your detector will give you valuable experience.
Ground Balancing Your Tiger Shark
Now that we have gone through the Quickstart, you are now ready to take your Tiger Shark out and learn
how to ground balance. (
Note:
If you have not gone through the Tiger Shark Quickstart, it is strongly
recommended that you do so before ground balancing your Tiger Shark.)
Ground balancing is a simple but very important skill that you must master to get the most out of your
detector. The Tiger Shark has controls that will allow you to tune the detector to the exact ground matrix
that you are hunting in. Finding and maintaining the exact tune or balance will give you the highest
possible depth and stability for your conditions. Once you have read through this section, it is most
important that you get out and practice your ground balancing skills as often as possible.
To start, find an area that is free of metal targets. If your coil is over any targets, it will always give a
positive signal and it will be impossible to correctly ground balance your detector. Start with your Tiger
Shark in the ALL MET FAST position. (You can use the ALL MET SLOW position, but it will take a
little longer to do your ground balance.) At this time, it will not matter where your GROUND ADJUST
knob is set. Place your DISC LEVEL at MIN and switch the MODE switch to NORM. After the battery
test is done, you are ready to begin the ground balance procedure. (
Note:
Unless you are on a wet salt
beach,
do not
use the SALT Mode. It will not ground balance to normal conditions. The SALT Mode is
to be used only on a wet salt beach.)
Lift your detector straight off of the ground about 6 to 8 inches.
Lift your detector straight off of the
ground about 6 to 8 inches. Keep the
coil parallel to the ground.
You must lift your coil straight up.
Do not swing it like a pendulum.
