ASSEMBLING YOUR DETECTOR
1) On the lower pole assembly, remove the mounting screw and thumb
nut from the pole tip.
2) Insert the pole tip between the mounting ears of the searchcoil and
align the holes of the pole tip and washers with those of the mounting ears.
Note: The pole tip should fit very snugly into the mounting ears.
3) Insert the mounting screw through the holes in the mounting ears and
pole tip—entering from the side opposite the cable connection.
4) Install the thumb nut on the mounting screw and tighten by hand.
Note: Do not overtighten the thumb nut. It should be snug but not too
difficult to loosen up.
5) On the middle pole assembly, depress the two spring buttons and slide
the middle pole assembly into the upper pole assembly until the spring
buttons click into the holes, locking the two assemblies into place. Tighten
the pole lock to secure the two assemblies together.
