6) Slide the lower pole into the middle pole until spring buttons click
into the first set of adjustment holes. Turn pole lock to tighten the assem-
blies into place.
7) Wrap the cable around the pole leaving enough slack near the searchcoil
to permit searchcoil adjustment.
Note: Do not allow the cable to flop loosely over the searchcoil. Since
the detector is sensitive enough to “see” the tiny wires in the cable, a
floppy cable can cause false signals as the searchcoil senses the moving
wires.
8) Plug the male cable end into the female connector on the control hous-
ing and tighten the cable thumb nut. You are finished!
Note: You will want to adjust the pole length and the searchcoil angle to
your preference.
