ACT6000 User Guide
– January 2021 Page 4 of 52
2. Safety and Conformity Information
The ACT6000 is intended for use by qualified personnel only.
The use of this tester is allowed in internal or external environments within the normal
human range of climatic characteristics (temperature and damp. It is recommended to work
with this tester within declared temperature limits (-5 ÷ +50°) and not in contact with water,
because it is not waterproof.
The ACT6000, like all the TesCom instruments, is "CE" certified for full electromagnetic
compatibility and safety. The stage In/Out (RTX connector) of the ACT6000 is designed for
use with circuits that have a maximum of 150 Vdc or peak AC wire-to-wire, or 75 Vdc or
peak AC wire-to-ground.
Warning ! The stage output of the instrument
“TX connector” is not protected !
Failure to comply with these precautions or with specific warnings in this guide violates the
safety standards of design, manufacture, and intended use of the tester.
TesCom assumes no liability for the
customer’s failure to comply with these requirements.
If this product is used in a manner not specified by the TesCom the protections provided by
the product may be impaired.
The
RTX
connector of the ACT6000 has an automatic protection device to protect against
over-voltage; over specified limits the protection activates and on the following message
appears on the display:
WARNINGS!
OVER VOLTAGE PROTECTION
VERIFY LINE CONNECTIONS - PUSH ANY KEY TO RESTORE
To restore the operation of the instrument, after verifying the correct state of the line, press
any key. In every case, to ensure correct galvanic isolation of the instrument during the
execution of high impedance measurements Insulation or DC capacitance, disconnect from
the instrument:
External AC/DC Battery Charger.
2.1. Community directive 2002/96/EC
Community directive 2002/96/EC for introduction in the market and to
disposal of
“WEEE” (waste electrical and electronic equipments)
containing
“RoSH” materials damaging to the environment and
detrimental to human health.
TesCom declares that all the materials, components, products supplied are fully compliance with
RoHS & Weee Directives. Nevertheless, the disposal of this equipment cannot be disposed as waste
but it has to be returned to the producer or to its official distribution network which will arrange to carry
out a separate collection.
In order to comply with what is mentioned above is stated that:
- even if the equipment does not contain dangerous elements listed on RoHS directives,
improper use could be detrimental to human health and damaging to the environment;
- the meaning of the symbol shown below and affixed on the equipment is to remind
that the same cannot be disposed of as
“waste”;
- penalties are to be expected in case of an abusive disposing of the equipment.