Tesco VCU10P, Руководство пользователя, Страница: 6 / 12

Inlet Tube Blockage Upper Hose Blockage
At the base of the cleaner there is a clear area of tube. Check If the inlet tube is clear and there is still a blockage:
this visually. If there is a blockage, undo the four screws,
1. Lift out the extension tubes
remove the cover plate and clear all debris. Replace the tube
2. Lift the hose handle out at the lower port
carefully in the duct, then replace the cover and fasten the
3. Press the two tabs at either side of the hose where it enters
screws tightly.
the upper inlet port of the cleaner.
4. Lift the hose out at the upper inlet port
5. Examine the tube and both ports and clear any blockage.
9. Now replace the hose and extension tubes.
VCU10P Vacuum Cleaner User Guide
When you have finished Vacuuming:
Set the cleaner fully upright.
Switch the cleaner off at the handle.
Unplug from the mains.
Set the cleats vertical and rewind the cord around the upper and
lower cleats.
Re-assemble the hose and attachments if necessary.
Fold the upper handle down fully.
Empty the dust cup and clean the dust cup filters (see Pages 7 & 8)
Wipe the cleaner body with a damp cloth and dry thoroughly.
Store the cleaner safely out of the reach if children and pets.
If the cleaner loses suction and the dust in the dust cup is below the MAX mark, this may be due to clogged filters or a blockage. DO NOT
operate the cleaner if the suction is impaired.
If you suspect a blockage:
$
Set the cleaner upright, switch off and unplug immediately. Empty the dust, check all the filters and clean them.
If this does not remove the blockage:
$
Check the extension tubes and accessories visually and remove any blockage with a stick or broom handle.
$
Invert the cleaner, inspect the brush area, and remove any obstruction from the bristles or the brush roller.
Clearing a Blockage
Cover Plate removed
showing tube
Page 6
IMPORTANT-Motor Thermostat
If the vacuum cleaner should overheat, the protective thermostat will automatically turn the unit off.
If this occurs: Switch off and unplug. Check and clear any blockage and clean/replace the filters.
Wait at least 45 minutes before attempting to reuse the cleaner. After the cleaner has cooled down plug in and
switch on. The vacuum should now start.
If the vacuum does not start: contact the help line on 0845 601 2549.
1 2
3
3
4