TESA CLINOBEVEL 2, Инструкция по эксплуатации

Страница: 14 / 44

5 x
ON/MODE
ENTER
ZERO/SELECT
14
– Function mode « ABSOLUTE »
6.3 Initial display setting on the centre of gravity through a reverse measurement,
then in a given angle α (ZERO-OFFSET function)
Function Key Display
CLINOBEVEL 2 is ready
to measure with display
set to zero based on the
centre of gravity as per
chapter 6.1
Initiate
ZERO-OFFSET function
Display shows the
correction value stored in
the memory for zeroing
CLINOBEVEL 2 based on
the centre of gravity
Select
given angle α
e.g. + 9°00’00”
Manual modification of the
displayed ZERO-OFFSET
value until the desired
value
∝
The « virtual zero », a freely selectable face
(e.g. an angle ∝ ) wil be considered as value
zero. The ZERO-OFFSET of the sensor
– determined by an opposed measurement –
can be modified using the « virtual zero »
α = 9°00’00’’