FF-MM-403-REV - 00
Page 3
Operation and Maintenance Guide Pneumatic Flexible Descaler TPFD75
Technical Data
IMPA Number
Equivalent
Model No
Max. Air
Consumption
No Load
Speed R.P.M
Weight, Kgs
59 12 51
TPFD 75
10 cfm
5000
21
Introduction
Teryair Pneumatic descaling machines are light and easy to handle, but rigidly constructed tools.
They efficiently handle heavy duty scaling. Required air pressure is 0.59 Mpa (6kgf/cm²).
Safety Instructions
Wear appropriate personal protective equip-
ments including safety goggles, foot wears, ear
defenders facemasks & hand-gloves.
Do not apply excessive load on the stiffeners
while working.
Do not store the shaft in incorrect method ot it
gives deformation to inners. The shafts should
be stored straight in racks with proper flat sup-
port flat support of wooden planks.
Please check the hose connection prior to start-
ing the Pneuamtic Flexible De Scaler.
Do not modify this equipment.
Do keep hand & clothing away from moving
parts.
Do not allow the equipment to run unattended.
Flexible De scaler should be store in dry envi-
ronment.
These tools may cause Hand - arm vibration
syndrome injury if there is not adequately
managed. We advice you to carry out a risk as-
sessment and to implement measures such as;
limiting exposure time (i.e. actual trigger time,
not total time at work) job rotation, ensuring
the tools are used correctly.
Air Supply
Tool should not be operated at air pressure
below 5.5 Bar (80 PSI) and above 6.9 Bar (100
PSI).
The correct oprating pressure is 6.2 Bar(90
PSI).
Ensure that only 3/8” (10 mm) bore airline is
used abd all couplings are thight, leakproof and
in good condition. The air should be clean, dry
lubricated. Install a FRL units as close as opera-
tion will permit.
Forward
At the outset we sincerely thank you choosing
our product. We at teryair always believe in
offering high quality products the
most reasonable prices. This belief has helped us
to innovate and incorporate new ideas and thus
enjpy a high degree of customer satisfaction.
This manual is designed keeping in mind all the
requirements of the customer in knowing the
prodcut its use.
This product is almost maintenance free. Only
continous air supply at 6.33 kg/cm2 is required.
Operating Instructions
Place Pneumatic Air Motor with trolley on floor.
Open Hose assembly (334 9728).On one of the
ends-rotary socket has female threads. Screw on
ths scoket on motor shaft. Tighten it fully. Then
screw on fixing adaptor on motor end shield.
With little force this will fit tight on motor. Then
open Tool box and select which of these assem-
biles do you prefer to use.
Following is the guideline for
selection
A. For Heavy rusting - Use No.1 H.D.Tool
(59 12 55)
B. For Light rusting - Use either No.2
L.G.Brush (59 12 60)
