FF-MM-403-REV - 00
Page 4
Operation and Maintenance Guide Pneumatic Flexible Descaler TPFD75
General Precautions
A. Ensure that the shaft is always driven in
the correct direction i.e. Anti-clockwise
as seen from front of the tool end.
B. Do not drag the unit with the help of
flexible shaft.
C. Excessive force on the outer casing or
on the inner shaft while disconnecting from
Motor or tool end will damage the shaft. Avoid
excessive force.
D. At least once in a month, remove the
inner shaft and lubricate with graphite grease
Or multipurpose 3 grease to get the better life
of the shaft.
E. Do not weld or braze the inner end fit-
tings.
F. The stiffeners are provided at either ends
of both outer casings to prevent excessive
bending of the shaft at the ends. Do not apply
excessive load on the stiffeners while Working.
G. On initial running after re-greasing or on
fitment of new inner shaft. The inner shaft Will
beat up heavily for few minutes before setting
to run smoothly. Hence run it Without any as-
sembly screwed on the tool end, till the initial
vibration settles down And then screw on any
selected assembly on the tool end.
H. Recommended minimum operating radi-
us for the shaft is 500mm.
Contents
1. 2 Nos - Fixed Spanner 20/22
2. 1 No - Pneumatic Air Motor mounted on
trolley
3. 1 No - Rubberised shaft Assembly
( 3349728 )
4. 1 No - Rubber Wheel Guard & Clamp
(342 40 16)
5. 1 No - Lubricator
6. 1 No - HD Tool Complete (59.12.55)
7. 1 No - LG Brush Complete (59.12.60)
8. 1 No - Hammer Head Complete
(59.12.66)
C. For wide rusting - Use Hammer Head
(59 12 66) equipment.
After selecting proper assembly, screw it on to
the another end of hose assembly (334 9728).
Also fit rubber guard over the flexible shaft
(tool end) connect it with electric socket. Hold
scaling device (selected assembly) in hand and
start air supply hold revolving part againts the
surface to be descaled. If the selection of as-
sembly is properly done as per application, you
will get the surface cleaned in very short time.
I. Incorrect method of starting the shaft,
gives deformation to inner components. The
Shaft should be stored straight in racks with
proper flat support of wooden planks.proper
flat support of wooden planks.
