FF-MM-314-REV - 06
Page 4
Operation and Maintenance Guide ERDS 84 Electric Rotary Deck Scalers
Warning
Before starting operation make sure to rotate
the hand wheel completely counter clockwise
so that cutter head don’t touch the surface.
Warning
Never operate without a belt guard.
Warning
This Deck Scaler is not designed for use in an
explosive environment.
Caution
Use only genuine Teryair or Teryair approved
accessories.
Caution
Always disconnect the power supply when not
operating.
Safety Wear Mandatory While
Operating Deck Scaler
Eye and face and ear protection must be worn
at all times during operation of the Deck Scaler
There is a chance of flying debris from the
jobsite and the quality of wear should be such
to protect against such flying debris such as
flakes of the removed layer.
Suitable gloves must be worn at all times
during operation.
Operators must wear helmets of suitable
strength at all times. Helmet must be able to
withstand 10G in 8ms without fracturing.
Waterproof heavy duty outerwear and Shoes
with toe cap protection are a must during
operation
Safety Instructions
Safety check before operating the Rotary Deck
Scaler
Un packing
1. Read section in “Operating and safety
precautions”.
2. Check the belt for correct for correct
tension or damage. To adjust belt read
Installation Instructions
Identify all the components as below, contact
your supplier if any parts are missing or dam-
aged.
Be aware that minor visual differences may
be noticed between actual motor because this
component
vary depending on the model ordered. This
illustration is for identification only.
Un packing
“ Belt tensioning”
3. Make sure the electric supply is con-
sistent with the electric motor require-
ments. The scaler comes with a standard
cable length of 20 meters, avoid losing a
conger cable to to avoid voltage drop.
4. Ensure that the job site is protected from
water, this scaler is rated IP44.
5. The Male plug portion is connected to
the Scaler (Factory fitted). The female
side electrical connection to be made at
customer end as per the model no. and
supplied voltage.
