terrysfabrics Cassette Roman Blind Kit, Как использовать

Страница: 2 / 5

STITCHING THE LOOP TAPE TO THE TOP OF THE BLIND
Remove loop tape from headrail.
A Fold over the top of the fabric 1cm ( 3 /
8
”).
B Place the loop tape over the fold leaving 0.5cm ( 3 /
16
”)
gap between the tape and the top of the fold.
Sew the tape into place with two rows of stitches - a row
on top and a row on the bottom of the tape.
STEP 3
SEWING THE BOTTOM BAR POCKET
Fold over and create a 4cm (1 5 /
8
”) pocket with a
turn over of 1cm ( 3 /
8
”) as shown in the diagram.
Stitch along the top edge hem/pocket.
STEP 4
Use Cassette Roman Blind Kit
Need some more help?
Talk to our customer service experts
on 01782 566 666
fabrics
MARKING THE TAPE POSITIONS
Divide the distance between the top and bottom of the
blind by 6 and mark at both sides the position.
With tailors chalk draw a faint line across the blind.
NOTE: Ensure the lines are parallel before sewing
blind in step 6.
STEP 5
SEWING THE TAPE TO THE BLIND
A
Rotate the tape so that it is in the upright position
with the rear pocket at the bottom of the tape as
shown opposite.
TRIM RODS AND TAPES ONLY IF REQUIRED
B
Measure and trim the 5 lengths of tape to the blind
width plus 1cm ( 3 /
8
”) at either end for seams.
C Place the lengths onto the chalk marks made
previously and turn one side of each length in
1cm ( 3 /
8
”) to form a hem on the tape.
D Sew to the blind with a row of stitching above the
pocket area leaving one pocket end open on each
to be hemed later.
STEP 6
Stitch
1cm
(
3
/
8
”)
Stitch
Pocket
Back
of tape
Stitch
Front of tape
Leave open
Stitch