Terratek PTS10U, Руководство пользователя

Страница: 12 / 52

7
This power tool is supplied with all the relevant safety guards and features, it should
be checked before every operation, this manual should be read and kept in a safe place.
Whilst we warn of all the possible risks attached to using power tools any operator must
have read and understood the manual and apply their own caution and common sense
when using this power tool.
Following this guide will greatly reduce your risk of electric shock or injury.
14. SECURE WORK. Use clamps or a vise instead of your hand to hold work when
practical. This safety precaution allows for proper tool operation using both hands.
15. DON’T OVERREACH. Keep proper footing and balance at all times.
16. MAINTAIN TOOLS WITH CARE. Keep tools clean and in good working condition
for maximum safety performance. Follow instructions for lubricating and changing
accessories.
17. DISCONNECT TOOLS BEFORE SERVICING – when changing accessories, such
as blades, bits, cutters, etc.
18. REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure switch is in
OFF position before plugging in.
19. USE RECOMMENDED ACCESSORIES. Consult the owner’s manual for recom-
mended accessories. The use of improper accessories may increase risk of injury.
20. MAKE SURE YOU USE THE CORRECT TOOL for the job you are doing.
21. NEVER STAND ON TOOL. Serious injury could occur if the wet saw is tipped or if
the cutting tool is unintentionally contacted.
22. CHECK DAMAGED PARTS. Before further use of the tool, damaged part(s), (i.e.,
guard) should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment of moving parts, binding of
moving parts, breakage of parts, mounting and any other condition that may affect
the tools operation. A guard or other part that is damaged should be properly rep-
aired or replaced.
23. Replace damaged blades immediately. DO NOT USE DAMAGED BLADES. They
may cause bodily injury.
24. DIRECTION OF FEED. Feed work into the blade against the direction of rotation
of the blade only.
25. DO NOT ALTER THE PLUG OR USE A 2-PRONG RECEPTACLE. This saw is
equipped with a 3-prong electrical plug.
26. NEVER LEAVE TOOL RUNNING UNATTENDED. Turn power off. Don’t leave tool
until it comes to a complete stop.