Page 45
472H Potato Harvester Owner Operator’s Manual
3.24 STORAGE (CONT’D)
19.
If the machine cannot be stored inside, cover with a
waterproof tarp and tie securely in place.
20.
Store out of the way of human activity.
21.
Do not allow children to play around stored unit.
3.24.2 REMOVING FROM STORAGE / PRE-
SEASON MAINTENANCE
When removing from storage and preparing to use, follow
this procedure:
1.
Clear the area of bystanders, especially small chil-
dren.
2.
Remove the tarp from the machine if covered.
3.
Clean off accumulated trash and dirt.
4.
Reassemble all parts taken off during post-season.
5.
Review and perform pre-delivery and run-in checklists
and daily maintenance.
6.
Check for any attachment available that will assist in
a better performance of the machine.
7.
Install all safety shields and review safety precautions
with operators and other personnel involved in the op-
eration.
8.
Check:
a. Tire pressure. Add as required.
b. Retorque all wheel bolts.
c. Retorque all hardware.
d. Adjust the routing and securing of all hydraulic
lines and wiring harness as required.
9.
Rotate all components and systems by hand to check
for any seized parts. Loosen any seized components
with penetrating oil before starting.
10.
Retighten any loose bolts to their specified torque.
11.
Lubricate all grease points, roller chains, and shaft
surfaces with sliding sprockets.
12.
Check all chains for correct tension and alignment.
13.
Check for excessive wear on all moving parts.
14.
Grease wheel bearing hub on rear transport wheels.
15.
Tighten all hydraulic connections and mounts, replace
o-rings, fittings, or connectors subject to leaking.
16.
Slip Clutch: - Release bolts, run to let slip, and reset
per instructions in the maintenance section of the
manual.
17.
Review Initial Operating Procedure.
18.
Review and follow all items on the Pre-Operation
Checklist and Pre-Start inspection before starting.
