17
Wall installation
The appliance must only be used if secured to a wall: the wall must be flat, smooth,
very stable (as the appliance could tip over) and resistant.
Position the appliance far from other sources of heat, inflammable materials (curtains,
carpets, etc.), inflammable gases or explosive materials (spray cans).
If the appliance is fitted to a wall, the same must be made of masonry and/ or of
resistant material (not of wood or synthetic material); follow the indications below for
installation:
The wall fan must be installed at least 2 m above the floor - Place the metal plate to
the wall, make 3 holes in the wall, as far apart as in Figure 1 (before drilling holes is
good to measure the distance between the slots above), insert the screw anchors
into the holes, place the plate metal and tighten the screws as shown in Figure 2,
attach the motor housing to the plate and secure it with the supplied screw (8).)
If fixed in a bathroom shall state that the heater is to be installed so that switches
and other controls cannot be touched by a person in the bath or shower.
Warning: don’t use wet hand touch the working machine and don’t cover the wind
outlet and inlet.
Before each use, verify that the heater is in good condition and that the electrical
cord is not damaged: in the case of doubt, ask for professionally qualified help.
Make sure that the cable is correctly positioned and that it is not in contact with hot
parts or sharp edges, nor wrapped around the device or twisted. • The power socket
must be easy to reach so the plug can be removed quickly in case of emergency.
