INSTALLATION
I
NSTALLING
T
HE
TRK-SR2 (
CONTINUED
)
Figure 9. Positioning the TRK-SR2 on a vehicle’s roof so the cable cover flap
extends over the rear window molding.
3. Continue placing the molding down on the roof, working forward towards the
antenna module. Examine the placement and make any desired adjustments.
4. Using steady pressure, firmly press the TRK-SR2 (including cable cover)
down for a minimum of 60 seconds to secure adhesion to the roof.
5. Push the cables under the rear window molding and route them to the XM
receiver, as shown in Figure 10 below. The cables can be routed separately (as
shown) or together along a single route.
Figure 10. Routing the TRK-SR2’s cable along a vehicle’s rear window.
NOTE: Use any existing cable channels (e.g., brake light opening) or wiring
conduits to route the cables.
8
Installation
TRK-SR2
Cable Under
Moulding
Flap
Cable Cover
TRK-SR2
XM Receiver
(In Trunk)
Cable
Cable
Push Cable
Under
Moulding
TRK-SR2 Install Guide 8/29/01 10:22 AM Page 8
