Terex PT-30, Руководство по обслуживанию

Страница: 61 / 116

Compact Track Loader
10. Transmission and Drive Disassembly and Assembly
10-4
Figure 10-9
3. Install the bolt on the left side of the auxiliary
gear pump.
Figure 10-10
4. With the end of the lower manifold tube inserted
in the transmission hose, slide the hose clamp to
the right and tighten the clamp.
5. Install the fuel tank. Refer to Chapter 6. Fuel
Tank Installation .
6. Install the seat. Refer to Chapter 6. Seat Instal-
lation .
7. Add fuel and manufacturer-approved hydraulic
fluid.
Tandem Pump Removal and
Installation
The tools required for tandem pump removal and
installation are listed in Table 10-2. Use manufactur-
er-recommended tools whenever possible.
Table 10-2
Required Tools
Screwdriver
Combination Wrench
Socket Wrench
Tandem Pump Removal
Hot oil can cause personal injury. Make sure the
oil is cool before removing any components or lines.
Remove the oil filler cap only when the engine is
stopped and has been allowed to cool thoroughly.
Collect and contain liquids in a suitable contain-
er. Dispose of all liquids according to local regula-
tions and mandates.
Note : During disassembly, cap all hoses and fittings to
prevent fluid loss and contamination of the system fluids.
1. Lower the lift arms to the ground.
2. Turn the engine start switch to the OFF position.
3. Relieve hydraulic pressure from the auxiliary
circuit.
4. Drain the hydraulic fluid. Refer to Chapter 16.
Hydraulic Fluid and Filter Change .
5. Remove the seat. Refer to Chapter 6. Seat Re-
moval .
6. Remove the fuel tank. Refer to Chapter 6. Fuel
Tank Removal .
7. Remove the auxiliary gear pump. Refer to Chap-
ter 10. Auxiliary Gear Pump Removal .
Install
Bolt
Slide Hose
Clamp to
Right and
Tighten
Lower
Manifold
Tube
Trans-
mission
Hose