Terex Fermec 760, Обучение по обслуживанию

Страница: 29 / 116

4004-4
29
Removing and installing the starter motor
Removing the starter motor
Remove the starter motor as follows:
1. Disconnect the battery.
NOTE : Make sure the key is removed from the start
switch on the side console.
2. Open the hood.
3. Remove the protective cover (13), the nut (12)
and the cover (14) from the solenoid (4).
4. Note the installed positions of the electrical
cables (9) and (17).
5. Remove the nut (11), the washer (10) and dis-
connect the four electrical cables (9) from the
starter motor (8).
6. Remove the two nuts (15), the two washers (16)
and disconnect the three electrical cables (17)
from the solenoid (4).
7. Attach the electrical cables (9) and (17) to the
structure of the engine with temporary ties.
8. Support the starter motor (8) and solenoid (4).
Remove the three nuts (7) and the “P-clip”
mounting bracket (6) from the studs (5).
9. Slide the starter motor (8) together with the sole-
noid (4) from the studs (5) and remove from the
engine.
10. Put a warning sign in the cab to tell persons not
to start the engine.
Installing the starter motor
NOTE : The installation of the starter motor is the
reverse of the removal.
Install the starter motor in the reverse order of the
removal but note the following:
1. Torque tighten the nuts (12): 12 Nm.
2. Torque tighten the nut (11): 6 Nm.
3. After installation do the following tests:
•
The battery voltage under load test, refer to
page 7.
•
The starter motor terminal voltage under load
test, refer to page 8.
•
The voltage drop on the insulated line test, refer
to page 8.
•
The voltage drop across solenoid contact refer to
page 9.
The voltage drop in earth line test, refer to
page 10.
Contents