Terex Fermec 760, Обучение по обслуживанию

Страница: 31 / 116

4004-6
31
Disassembling the starter motor
Disassemble the starter motor as follows:
1. Remove the starter motor, refer to page 4.
2. Remove the solenoid assembly, refer to page
14.
3. Remove the end-cover, refer to page 12 (steps 3
through 6).
4. Remove the field winding brushes (10) from
brush plate.
5. Remove the rubber grommet (13).
6. Slacken the locknut and remove the pivot pin
(4). (The pivot is eccentric to the screw thread to
allow adjustment of the pinion gear end-clear-
ance).
7. Remove housing (2) and the pinion engagement
lever (1).
8. Remove the armature and pinion assembly (9)
from the motor body.
9. Use a suitable tube to punch the thrust-collar (6)
towards the pinion and expose the snap-ring (5).
10. Remove the snap-ring (5).
11. Remove the thrust-collar (6).
12. Pull the pinion and the roller clutch (7), off the
armature shaft.
13. Pull the intermediate plate (8) off the armature
shaft.
14. Remove the four screws (11) and carefully pull
the field windings (12) from the motor body.
15. Inspect and test the starter motor, refer to page
14.
Assembling the starter motor
NOTE : The assembly of the starter motor is the
reverse of the disassembly.
Assemble the starter motor in the reverse order of the
disassembly but note the following:
1. Apply Shell Retinax “A” grease or its equivalent
onto the drive shaft splines, the thrust-collar (6)
and the engagement lever (1).
789M049A
Contents