18
4 .3
4 .3
Fir m w a re
Func t iona lit y
Fir m w a re Func t iona lit y
Below describes some of the features implemented in the LED example.
•
MTS/MFS
Using the MTS/MFS jumper, you can enable/disable the MTS/MFS feature.
•
ARST
The Sensor Auto Reset time can be controlled on the ARST jumper. When Auto Reset feature is
enabled, if a key is pressed/active for more than 5, 20 or 40 seconds the device resets the key.
•
Scan Rate
The firmware reads resistor values and reset sets the scan rate of the CapSense device.
Scan Rate configuration:
1.
Pin grounded – low
2.
1.5K(5%) ohms resistor to ground – medium
3.
5K (5%) resistor to ground – high
4.
Pin connected to V
DD
or left floating – continuous
•
Deep Sleep Control
The Deep Sleep jumper setting sets the device to active or deep sleep modes.
Deep Sleep configuration:
1.
Pin grounded – Sleep state disabled
2.
VCC_SYS – Sleep state enabled
