KRB-5200h
-2-
2. RECEIVING AND HANDLING
2.1 Unpacking Precautions
The ACB from Terasaki is completely assembled, inspected and tested both electrically and
mechanically at the factory, then shipped in fully guaranteed conditions in construction and
operation. Upon receipt of your ACB, check the following. If you have any question or any
problem, contact your local agent or our branch office.
1) Check that the ACB is not damaged during shipment.
Caution : During unpacking, do not lay the plug-in type ACB on a flat surface with the backside
down.
Doing so may cause damage to the auxiliary terminals.
2)
Check that the ratings shown on the ACB nameplate, OCR nameplate, and accessory
nameplate are as you specified.
When the ACB is equipped with the XMD4M motor operator, remove the motor operator
before checking the OCR nameplates. The motor operator is hinged. For procedures for
removing and mounting the operator, see
[3] Before and After Checking the Trip Settings
,
XMD Series Motor Operator - Operating Instructions.
2.2 Transportation Precautions
1) Use both hands to transport the ACB. A heavy ACB should be carried by two persons.
Dropping or toppling the ACB may cause damage to it or personal injury.
ACB Mass
(kg)
ACB type
Manual operated
Motor operated
Rear-connected
Plug-in
Rear-connected
Plug-in
AME3B, AME4B
6.5
5
11.2
9.7
AME6B
10
9.6
15.6
15.2
AME8B, AME10B
19.5
16
25.9
22.4
2)
Do not carry the ACB by the auxiliary terminal block or stud bar.
Doing so may cause damage or dropping.
3)
Avoid strong vibration or shock to the ACB during transportation or installation.
Otherwise, damage may result.
2.3 Storage Precautions
It is recommended that the ACB be used as soon as you have received it. If it is necessary to store
the ACB for some time before its installation, please note the following for proper storage:
1) Store the ACB in a dry indoor location to prevent condensation due to sudden changes in
temperature.
Condensation has a harmful effect on the ACB insulation.
2) Store the ACB in a clean place free of corrosive gases, dirt and dust. In particular, a mixture
of cement dust and moisture can cause corrosion in the various metal parts of the ACB, and
fully protect the ACB from such mixtures.
Floor
Terminal contacting with floor surface
Содержание AME Series
Страница 2: ...KRB 5200h ...
Страница 6: ......
Страница 32: ...KRB 5200h 26 5 3 Operation Characteristic Curves ...
Страница 39: ...KRB 5200f ...