7-8
7.5.2
Parameter setting procedure
Parameters are set in “Setting mode.”
c
Entering the setting mode
When the normal indication is displayed, hold down the
Setting
switch for at least 3 seconds to enter
the “setting mode.”
When the system enters the setting mode, the basic parameter selection screen appears, and the
indicator lamp alternately shows
and the set value.
The parameter selection screen alternately shows a parameter name and its set value.
d
Selecting a parameter to be set
Press the
1
or
1
switch to cycle through the parameters until the target parameter appears.
To select an extended parameter, press the
Confirm
# 1
Manual
switch while
is displayed, which enters
the extended parameter selection screen.
To return to the basic parameter selection screen from the extended parameter selection screen,
press the
Back
# 2
Manual
switch.
e
Changing a set value
Press the
Confirm
# 1
Manual
switch on the parameter selection screen to enter the set value change screen.
Only the preset value is shown in the set value change screen.
Press the
1
or
1
switch to change the set value.
Note
Extended parameters can be changed only when the operation mode is set to
“Stop.”
In the “Manual” or “Auto” operation mode, pressing the
Confirm
# 1
Manual
switch on the
extended parameter selection screen the alartm will sound a warning buzzer
and does not enter the set value change screen.
f
To save the change of the set value
When you have changed the set value, press the
Confirm
# 1
Manual
switch to confirm the change of the set value.
When the change is entered, the system makes a beep sound and the display flashes three times.
Then it automatically goes back to the parameter selection screen.
