A S T 3 9 8 8 0 ( 0 8 0 7 )
2 2 o f 3 0
6 . 3 C o n t r o l U n i t / M o d u l e U p d a t e i n S t o r a g e M o d e
NOTE:
•
Storage Mode works similar to Pass-thru Mode. You will see the same CM Update
software screens during the vehicle system selection. To complete a Storage Mode
update at the vehicle, you need the Trigger Switch Adapter Block (TDS3554 1434)
and the Trigger Switch (TDS35541 359).
•
These instructions are a summary of the updating process.
•
For a description of the GNA600 Kit parts used in this procedure, refer to section 3.3.
1. Connect the USB PC Interface Cable to the
i
N Workstation and to the GNA600. From the
Updating Honda Control Modules
main screen, select
Storage Mode
and follow the
on-screen instructions.
2. Connect the DLC Cable to the GNA600 and to the vehicle’s DLC. (You don’t need to turn
the ignition switch to ON (II) before connecting the GNA600. This applies only to the HIM.)
3. Turn the ignition switch to ON (II), and wait until the green #2 LED on
the GNA600 stays on. Turn the ignition switch off, and disconnect the
DLC Cable from the vehicle.
4. Connect the USB PC Interface Cable to the
i
N Workstation and to
the GNA600. Connect the Power Supply Unit and Power Supply
Cord to the GNA600. The GNA600 will start a self-check. After
about 30 seconds, the GNA600 LEDs flash green and yellow.
5. Select the vehicle system that you are updating, then click on the
Check Mark
on the right
side of the screen.
