Marquee™ Point-to-MultiPoint Series User Guide
3. Turn the pivot adaptor bracket (B) so that the rectangular part is parallel with the surface of the
Marquee P-MP FP. Fasten the Marquee P-MP unit to the pole using pole clamp (C), U-bolt (D), and
two nuts, as shown in Fig 2.5. Tighten hardware (two places). The pole clamp (C) and U-bolt (D) will
accept pole diameters between 0.75” to 1.5” OD.
Figure 2.5 – Attaching the Marquee P-MP FP Unit to the Pole
(D)
(B)
(C)
Min 0.75”
Max 1.5”
(A)
Proceed to Section 2.7 – Cabling the Marquee P-MP (All Enclosures).
2.6
Hardware Installation – EX Enclosure
NOTE:
All connectors must be properly water-proofed with all-weather electrical tape, Permagum, or
equivalent.
Do not use Silicon glue
.
The Marquee P-MP EX unit is installed by using an “X”-shaped adaptor bracket (A) that is secured to the
pole with a pole mounting bracket (B), and a pole clamp (C). Figure 2.6 shows the hardware provided to
mount the Marquee P-MP EX unit.
Figure 2.6 – Marquee P-MP EX Mounting Hardware
Hardware Qty
Screw Hex Head M5x20
4
(for TeraBridge 5x45 only)
Screw Hex Head M8x40
4
(for poles between 1” to 1.75” OD)
Screw Hex Head M8x70
2
(for poles between 1.75” to 3” OD)
Lock Washer M5 (with a cut)
4
Flat Washer M5 (solid)
4
Nut M5
4
Lock Washer M8 (with a cut)
4
Flat Washer M8 (solid)
6
Nut M8
2
Arm (For indoor
installations only,
not used)
“X”-Shaped Adaptor
Bracket (A)
Pole Clamp (C)
Pole Mounting
Bracket (B)
Version 1.3(a)
Page 6
Jul 2005
