Setup Menu Tree
13-280142 Rev. B
Page 19
D
D
i
i
a
a
l
l
i
i
n
n
g
g
M
M
o
o
d
d
e
e
Dialing Mode controls automatic dialing.
•
NORMAL – after the user has entered all digits, they must tap the voice or video
icon to manually initiate dialing, or wait for the number of seconds set in
TIMEOUT
(SEC)
for automatic dialing.
•
WARM DIAL – when the phone goes offhook, it will automatically dial the number in
the
DESTINATION
field after the number of seconds set in
TIMEOUT (SEC)
. A user
can dial a different number before the timeout, canceling the automatic dialing.
•
HOT DIAL – similar to WARM DIAL, but automatic dialing occurs immediately after
the phone goes offhook (no timeout).
N
N
e
e
t
t
w
w
o
o
r
r
k
k
R
R
e
e
s
s
o
o
u
u
r
r
c
c
e
e
s
s
Basic network information is typically provided by DHCP. SIP OPTIONS and SIP PROXY
SERVERS should be set explicitly via configuration download.
•
IP Address – To set the IP address, subnet mask, and default gateway statically,
uncheck AUTOMATICALLY
OBTAIN FROM DHCP
. Leaving the fields blank will
allow static network information to be set locally at the phone, otherwise set values
as desired.
•
DNS – To set the DNS server(s) statically, uncheck AUTOMATICALLY
OBTAIN
FROM DHCP
. Leaving the fields blank will allow static name server values to be set
locally at the phone, otherwise set values as desired.
•
NTP – To set the NTP server(s) statically, uncheck AUTOMATICALLY
OBTAIN FROM
DHCP
. Leaving the field blank will allow the time server(s) to be set locally at the
phone, otherwise set value as desired.
•
SYSLOG – To manually enable syslog, check
ENABLE SYSLOG
, and
fill in the
SERVER ID
and
LOG LEVEL
information.
•
SIP OPTIONS – Change the
TRANSPORT
,
NAT KEEP ALIVE
, and
NAT TIMER (SEC)
options if required by your network.
•
SIP PROXY SERVERS – Select
+PROXY
and enter the Teo UC server IP address or
fully qualified domain name and port. If a backup server is installed, enter that
address below the primary server. If no proxy server is entered, the primary server
address is assumed to be the same as the Update Server address.
