TensCare itouch easy, Инструкция по эксплуатации

Страница: 14 / 22

24
23
14. THE BELT CRADLE
In order to be able to wear the “itouch easy” around the waist a
belt cradle is supplied.
Attaching the belt cradle: To attach the belt cradle push the
“itouch easy” upwards into the cradle so that it slides between
the two sides of the cradle and slots into it with the two notches
on the inside of the cradle going into the two holes in the top of
the unit.
Removing the belt cradle:
To remove the cradle push a finger
through the hole at the back of the cradle while holding onto it.
NB: Do not attach the mono leadwire before attaching the belt
craddle to the unit and it is necessary to detach the mono leadwire
before removing the craddle
15. CLEANING
The case and lead wires can be cleaned by wiping with a damp
cloth and a solution of mild soap and water. Wipe dry.
Do not immerse your TENS machine in water.
Do not use any other cleaning solution than soap and water.
Clean the case and lead wires at least once a week by wiping with
a damp cloth and a solution of mild soap and water. Wipe dry.
16. TROUBLESHOOTING
Problem Possible causes Solution
No display
Flat batteries Replace batteries
Batteries inserted incorrectly Check
Damaged battery contacts Contact supplier
Low battery display
Low batteries Replace batteries
No sensation Incorrect connection Have you applied both
electrode pads (per lead wire)
to ensure a complete circuit?
Not strong enough Increase strength.
Most users will feel something
at a setting below 20
Pad Alarm Poor pad condition Ensure machine is attached to
your body correctly.
Clean skin and press pad firmly.
Wait 5 minutes for pad to
absorb skin moisture.
Lead not connected to Are you using left hand
body correctly control for two white leads
and right hand control for two
black leads?
Lead faulty/damaged Purchase replacement
if necessary.
If the above review has failed to resolve your problem, call TensCare or your local
dealer (address on back cover) for advice.