TensCare BEAUTYMAX, Инструкция по эксплуатации, Страница: 26 / 38

25
10.2. OPERATING
INSTRUCTIONS
ON/OFF
To turn the unit ON, press the
ON/OFF button on the top of the unit
and hold for 3 to 5 seconds until the
display shows.
To turn the unit OFF, press the
ON/OFF
button on the top of the unit and hold for
3 to 5 seconds until the display stops
The unit will turn OFF automatically:
When the Timer reaches zero,
If it is left at zero strength for more than
5 minutes.
The unit will start with the programme
you used last.
At first use, or after changing batteries,
the display shows that the unit is
automatically set in programme FACE
at zero strength.
Note: Always check unit is
OFF before applying or
removing electrode pads.
The backlight will turn off 10 seconds
after the last button press.
On the front of the unit there are six
buttons:
STRENGTH CONTROLS
The buttons marked CH1 ▲ , CH1 ▼ ,
CH2 ▲ , CH2 ▼ are the strength
controls.
The left-hand buttons
change strength in the
left-hand lead, CH1,
and the right-hand
buttons change the
right-hand lead, CH2.
To increase strength in steps of 1 mA,
press and release the top part of the
channel buttons, CH1 ▲ and CH2 ▲ .
The strength levels are shown on the
LCD.
The strength control buttons will not
operate until the unit is properly
connected to you. If the Beauty Max
detects a disconnection in either
channel it will automatically return
the strength to zero in that channel
and flash ‘00’.
The unit has 90 levels of strength
except for the facial programme which
only go up to 40 mA (40 steps).
If you hold down the strength controls
for 3 to 5 seconds, the strength will start
increasing continuously.
You may feel nothing over the first few
presses. Continue pressing until the
sensation is strong but comfortable. At
each phase of the programme the
intensity automatically adjusts to give a
comfortable stimulation, however
further increases during use may be
necessary if your body becomes used
to the sensation. To decrease the
strength, press and release the lower
part of the buttons marked CH1 ▼ and
CH2 ▼ .
The yellow LED on the output socket
indicates that there is an active output
which can be high enough to be harmful
if not used correctly. The display will
remain on for 5 seconds after the plug
is removed.
▲
CH1
▼
▲
CH2
▼