Tennant T300e, Руководство оператора

Страница: 9 / 75

English
EN
9
Tennant T300e (07- 2022)
INSTALLING BATTERIES
WARNING: Batteries emit hydrogen gas.
Explosion or fire can result. Keep sparks and open
flame away when charging.
FOR SAFETY: When servicing machine, wear
appropriate personal protection equipment as
needed. Avoid contact with battery acid.
BATTERY SPECIFICATIONS
Two 12 volt deep-cycle batteries.
Contact distributor or Tennant for battery
recommendations.
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, turn off machine and remove
key.
1. Lift the recovery tank to access the battery
compartment (Figure 1).
FIG. 1
2. With adequate assistance, carefully install the
batteries into the battery compartment. Arrange the
batteries as shown (Figure 2).
FOR SAFETY: When servicing machine, use a hoist
or adequate assistance when lifting batteries.
3. Using the supplied battery post boots, connect the
cables to the battery posts as shown (Figure 2).
Connect the machine’s black (- ) battery cable last.
Use insulated tools when working near batteries.
M
achi
n
e
F
ront
BLACK
RED
FIG. 2
IMPORTANT: Make sure that the machine’s battery
charger is properly set before charging. To change
the off- board battery charger settings, refer to the
charger’s owner manual.
MACHINE SETUP
ATTACHING SQUEEGEE ASSEMBLY
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, turn off machine and remove
key.
1. Lift the squeegee mount bracket to the raised
position. Place toe under pedal to lift (Figure 3).
FIG. 3
2. Mount the squeegee assembly to the squeegee
mount bracket (Figure 4). Tighten knobs to secure
squeegee assembly to bracket.
FIG. 4
3. Connect the vacuum hose to the squeegee
assembly (Figure 5).
FIG. 5