Tennant 96GR, Руководство оператора, Страница: 31 / 84

OPERATION
2-15
95GR MM199 (10---89)
POST OPERATION CHECKLIST --- ENGINE
OPERATING
Check brush patterns for width and taper.
TO STOP MACHINE
1. Return the directional control pedal to the
“neutral” position. Apply the brake.
2. Pull the main brush lift lever back into the
“raise” position.
3. Press the side brush position switch back into
the “up” position.
4. Move the main brush power lift lever into the
“up” position.
5. Move the main brush speed lever into the “off”
position.
6. Move the side brush lever into the “off”
position.
7. Turn the operating lamps off if used.
8. Place the throttle lever in the “idle” position.
9. Engage the machine parking brake.
10. Turn the ignition switch key to the “off” position.
Remove the key from the switch.
WARNING: Always stop the machine on a
level surface, stop the engine, and engage the
parking brake before leaving the machine
unattended to keep it from rolling.
POST OPERATION CHECKLIST --- ENGINE
STOPPED
Check skirts for damage, wear, and adjustment.
Check for wire or string tangled on brushes.
Check for leaks.
OPERATION ON GRADES
Drive the machine slowly on grades. Use the service
brakes to control machine speed.
WARNING: Always travel slowly on grades
to prevent machine from becoming
unstable. When going down a grade, use service
brakes to control speed. Do not operate machine
on greater than maximum rated climb and
descent angles.
The maximum rated ramp climb and descent angle
is 15
_
with an empty hopper, and 12
_
with a full
hopper.