ENGLISH
EN
BR2020/T (04–98)
7
MACHINE OPERATION
Read and understand SAFETY PRECAUTIONS
section before operating machine.
PRE–OPERATION
1.
Sweep floor and remove debris.
2.
Check condition of pad.
3.
Check battery charge level.
(For accurate
reading brush must be spinning)
4.
Check that dust control bag is installed.
5.
Make sure floor is dry.
BURNISHING WITH THE BR2020
1. Turn on key and main power switch.
2.
Twist control grips forward to lower pad to
floor and to start pad motor.
Twist Grips to Activate Pad
3.
Begin burnishing by pushing machine forward.
NOTE: If machine vibrates, realign pad.
CAUTION: Keep machine moving at all
times to prevent floor damage, .
4.
Adjust pad pressure meter within Green
Zone. Press the Pad Pressure switch to
decrease or increase pressure. For best
results adjust needle as shown.
Meter Needle
GREEN
ZONE
RED
ZONE
Pad Pressure Meter
CAUTION: Never operate in Red zone,
floor damage and brush motor overload may
result.
5. Release grips to stop burnishing. The pad will
automatically raise to the transport position.
CAUTION: When transporting machine
without burnishing, tilt machine back to
protect dust skirt.
BURNISHING WITH THE BR2020T
1.
Release parking brake lever if set.
2. Turn on key, main power and brush switches.
3.
Turn speed control knob to slowest speed.
This will prevent an abrupt take off.
Adjust Speed Control Knob
4.
Twist control grips forward to begin
burnishing. Gradually turn speed control knob
to desired cleaning speed.
Twist Grips to Burnish
CAUTION: For first time users, operate at
a slow speed until maneuvering becomes
easy.
5.
Adjust pad pressure meter within Green
Zone. Press the Pad Pressure switch to
decrease or increase pressure. For best
results adjust needle as shown.
