Tennant 215E, Руководство оператора

Страница: 51 / 62

MAINTENANCE
3-27
215E MM158 (11--91)
REAR SKIRTS
The rear skirts seal the brush compartment. They
are located on the bottom rear of the brush
compartment. The seals should be inspected for
wear or damage daily.
TO REPLACE AND ADJUST REAR SKIRTS
1. Stop the machine on a smooth, level
surface.
2. Stop the motor and set the machine parking
brake.
FOR SAFETY: Before Leaving Or
Servicing Machine; Stop On Level
Surface, Set Parking Brake, And Turn
Off Machine.
3. Unlatch and open the left side access door.
4. Loosen the two right side access door
screws and remove the right side access
door.
5. Remove the rear skirt retaining strips and
the rear skirts.
A
C
B
01802
REAR SKIRTS
A. Brush Skirt
B. Vertical Rear Skirt
C. Retaining Strip
6. Loosely install new skirts with the existing
retaining strips.
7. Slide the vertical rear skirt up or down so it
is 0 to 0.12 in (0 to 5 mm) above the floor.
8. Retighten the retaining strip bolts.
HOPPER LIP SKIRT
The hopper lip skirt floats over debris and helps
deflect that debris into the hopper. It is located on
the bottom rear of the hopper
The hopper lip skirt should be inspected for wear
or damage daily.
TO REPLACE HOPPER LIP SKIRT
1. Empty the machine debris hopper.
2. Raise the hopper.
3. Engage the hopper support bar.
WARNING: Raised Hopper May Fall.
Engage Hopper Support Bar.
4. Stop the machine on a level surface, stop
the motor, and set the machine parking
brake.
FOR SAFETY: Before Leaving Or
Servicing Machine; Stop On Level
Surface, Set Parking Brake, And Turn
Off Machine.
5. Remove the skirt retaining strip and the
skirt.
A
C
B
03084
HOPPER LIP SKIRT
A. Hopper
B. Lip Skirt
C. Retaining Strip
6. Position the new skirt on the hopper. Secure
it in place with the retaining strip.
7. Raise the hopper, disengage the hopper
support bar, and lower the hopper.