42
Enabling Frequency Sweep
•
Press
Menu→Sweep→Type→Linear
to switch
on linear sweep function.
Selecting Frequency Sweep Waveforms
•
With linear sweep enabled, press
Carrier→Square MHz
and the interface (right)
will be on display:
•
In this interface, use the multipurpose knob and
direction buttons to set the amplitude, or press
Params
to reveal the display shown (right).
•
To set the desired parameter, press the
corresponding MHz, then enter in the desired
value and select the unit as required.
Setting Start/Stop Frequency, Sweep Time,
Trigger Source and Trigger Edge
•
With frequency sweep waveform and its
parameters set up, press
Return MHz
to return
to the interface (right).
•
In the interface (above right), use the
multipurpose knob and direction buttons to
perform the setting, or press
Params
to show
the display (right).
