www.element14.com
www.farnell.com
www.newark.com
www.cpc.co.uk
TM
TM
Page <8>
V1.0
12/03/19
MODE Button
To select OHM/Diode/Continuity/CAP
HZ/% Button
With rotary switch on HZ/%, Voltage, Current, positions, the Hz% key permits to select the frequency test (Hz) or the duty cycle
test(%).
REL Button
1. Press the REL button to zero the display. “ ” will appear in the display. The displayed reading is now the actual value less
the stored “zero” value.
2. To exit this mode, press and Hold the REL button until “ ” is no longer in the display.
DATA HOLD Button
To freeze the LCD reading, press the HOLD button. While data hold is active, the HOLD icon appears on the LCD. Press the
HOLD button again to return to normal operation.
LCD Backlight Button
The LCD is equipped with backlighting for easier viewing, especially in dimly lit areas.
Press the HOLD button for over 1 second to rum the backlight on. Press again for over 1 second to rum the backlight off.
Automatic Power OFF
In order to conserve battery life, the meter will automatically turn off after approximately 30 minutes. To rum the meter on again,
turn the function switch to the OFF position and then to the desired function position.
7. Maintenance
WARNING: To avoid electrical shock, disconnect the meter from any circuit, remove the test leads from the input terminals, and
turn OFF the meter before opening the case. Do not operate the meter with an open case.
Cleaning and Storage
Periodicallywipethecasewithadampclothandmilddetergent;donotuseabrasivesorsolvents.Ifthemeterisnottobeused
for 60 days or more, remove the battery and store it separately.
Battery Replacement
1. Remove the Phillips head screw that secures the rear battery door
2. Open the battery compartment.
3. Replace the 1.5V*2 AAA battery.
4. Secure the battery compartment.
Important Notice :
This data sheet and its contents (the “Information”) belong to the members of the Premier Farnell group of companies (the “Group”) or are licensed to it. No licence is granted
for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change
without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any
error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any
assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the
Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group’s liability for death or personal injury resulting from its negligence.
Tenma is the registered trademark of the Group. © Premier Farnell Limited 2016.