www.element14.com
www.farnell.com
www.newark.com
www.cpc.co.uk
TM
TM
Page <6>
V1.0
12/03/19
Operating Humidity
Max 80% up to 31°C (87°F) decreasing
Storage Humidity
linearly to 50% at 40°C (104°F)
<80%
Operating Altitude
7000ft. (2000 meters) maximum.
Battery
2×1.5V AAA Battery
Auto Range
Auto power OFF
After approx. 30 minutes
Dimensions & Weight
Safety
For indoor use and in accordance with the requirements for double insulation to
IEC1010-1 (2001): EN61010-1 (2001)
Over voltage Category II 1000V and
Category III 600V, Pollution Degree 2.
6. Operation
NOTES: Read and understand all Warning and Caution statements in this operation manual prior to using this meter. Set the
function select switch to the OFF position when the meter Is not In use.
6-1. AC Current Measurements
WARNING: Ensure that the test leads are disconnected from the meter before making current clamp measurements.
• Set the Function switch to the AC Current.
• Place the current fork around the middle of the test lead.
• The clamp meter LCD will display the reading.
6-2. AC Voltage Measurements
•
InserttheblacktestleadintothenegativeCOMterminalandtheredtestleadintothepositiveVHz%ΩCAP
TEMP
terminal.
• Set the Function switch to the AC Voltage.
• Connect the test leads in parallel to the circuit under test.
• Read the voltage measurement on the LCD display.
6-3. DC Voltage Measurements
•
InserttheblacktestleadintothenegativeCOMterminalandtheredtestleadintothepositiveVHz%ΩCAP
TEMP
terminal.
• Set the Function switch to the DC Voltage.
• Connect the test leads in parallel to the circuit under test.
• Read the voltage measurement on the LCD display.
6-4. Resistance Measurements
•
InserttheblacktestleadintothenegativeCOMterminalandtheredtestleadintotheVHz%ΩCAP
TEMP positive
terminal.
•
SetthefunctionswitchtotheΩCAP
position.
• Use the MODE button to select Resistance Measurements
• Touch the test probe tips across the circuit or component under test.
• Read the resistance on the LCD display.
Note : when set this position, Date Hold and black light function cannot used.
6-5. Continuity Measurements
•
InserttheblacktestleadintothenegativeCOMterminalandtheredtestleadintotheVHz%ΩCAP
TEMP positive
terminal.
• Use the MODE button to select continuity “ ”. The display icons will change when the MODE button is pressed.
• Touch the test probe tips across the circuit or component under test.
•
Iftheresistanceisatlessthan50Ω,atonewillsound.