147
Chapter 5 Fault Handling
Possible faults in the use of the function/arbitrary waveform generator and troubleshooting methods are listed below. If
these faults occur, please follow the corresponding steps. If they cannot be corrected, please contact the supplier, and
provide the information about your machine (method: press Utility and System in sequence).
5.1
No Display
on Screen (Blank Screen)
If the signal generator still does not display after pressing power switch on front panel
1) Check that the mains lead is connected and mains power is turned on.
2) Check the fuse in the mains plug.
3) Check whether the power switch on back panel is in the ON position.
4) Check that the power switch on front panel is in the ON position.
5) If the product still cannot be used normally, please contact the supplier you purchased it from.
5.2
No Waveform Output
Setting is correct but no waveform is output
1) Check whether the BNC cable and channel output terminal are connected correctly.
2) Check that either CH1 or CH2 is turned on.
3) If the product still cannot be used normally, please contact the supplier you purchased it from.
5.3
Fails to Correctly Recognize U Disk
1) Check whether U disk works normally.
2) Check that only Flash U disk is used. The instrument does not support hard disk.
3) The U disk must be formatted Fat 16 or Fat 32.
4) Restart the instrument, and insert U disk again to see whether it works normally.
5) If the U disk still cannot be used normally, please contact the supplier you purchased it from.
