11
3.2.2 Amplitude Setting
Defaultwaveform: A sine wave of 100mV peak-peak value with
50Ω termination.
Steps for changing the amplitude to 300mV are shown as follows:
1.
Press Menu
→Waveform→Parameter→Amplitude in turn. Press Amplitude softkey again can switch between
Vpp, Vrms, and dBm.
2.
Use number keys to input 300.
3.
Select required unit: Press unit softkeymVpp.
Note: This parameter can be set by multifunctional control and direction buttons.
3.2.3 DC Offset Voltage Setting
The default waveform is a sine wave with 0V DC offset voltage (with 50Ω termination).
Steps for changing DC offset voltage to -150mV are shown as follows:
1.
Press Menu
→Waveform→Parameter→Offset to enter parameter setting.
2. Use number keys to input the required number of -150.
3. Select corresponding unit mV.
Note: This parameter can be set by multifunctional control and direction buttons.
