6
TENA Identifi™
System
TENA Identifi™
System
7
1 min
Cleaning the logger
Cleaning the logger
Apply protective gloves before handling the logger and prior to
cleaning and disinfection. Always clean and disinfect the logger
before placing it back in the charger.
Do not use dishwasher or autoclave.
Do not use the TENA Identifi™ Logger on individuals known to carry
antibiotic resistant bacteria or contagious diseases. If the logger
was mistakenly used on such individuals, follow your organization’s
infectious materials handling and infection control protocols.
The plastic surface of the TENA Identifi™ Logger is compatible with
the following non-corrosive disinfectants:
• hypochlorous solutions
• quaternary ammonium compound solutions
Do not use chlorine bleach (Sodium hypochlorite solution) on the
logger device.
1.
Clean every surface including crevices with water and detergent
or pre-moistened cleaning wipe by rubbing the logger for at least
1 minute.
2.
Dry the logger with a paper towel or disposable dry wipe.
Proceed with disinfecting the logger as described below.
4.
Allow the logger to air-dry completely. The logger is now ready
to place back in the charger.
3.
Disinfect the logger. Use a disinfectant suitable for low risk
equipment to inactivate pathogen microorganisms. Example
disinfectant products are:
• 70% alcohol
• Virkon
®
containing the active ingredient hypochlorous solution
Rub every surfaces including crevices and make sure surfaces and
crevices are completely saturated with the disinfectant.
Follow the manufacturer’s recommended instructions for use of
the disinfectant.
Virkon is a registered trademark of E. I. du Pont de Nemours and
Company or its affiliates.