1wddfdfasdfsfs
STEP 10.
1. Identify the head end of your slatted
frame, this will be the end with holes.
2. Carefully lower the slatted frame into
the base so that it rests on the hinges
and the support brackets. Again, this will
require two people to do safely.
3. Align the holes on the frame with the
holes on the hinge and pass the three
M6 x 60mm bolts through the washers
provided and then into the holes each
side of the frame.
4. Place a nut onto each of the M6 bolts
and tighten with fingers, then, using the
Allen key provided, fully tighten.
5. The slatted frame and base are now
joined.
STEP 11.
WARNING: Please take care
when putting mattress onto frame
1. Once both struts are fixed to the hinges the
bedstead is now ready for the mattress.
2. Place mattress on top of the frame
T
ake care when doing this as
the frame can spring upwards
without the weight of the mattress.
STEP 9.
WARNING: Please take care not to trap
fingers in hinges.
1. While one person holds the slatted frame up, the second
person must fit the gas strut to the hinge.
2. One end of the strut will already be attached to the
hinge. At the other end, take the nut off the bolt and
attach the other end of the strut.
3. Once this is in place, replace and tighten the nut.
4. Repeat process for the other side of the bed.
3. Check bolts on the ottoman action every
few months.
