10
11
ASSEMBLY STEp 1
A Open
hardware for step 1
.
B Attach the
front stabilizer
tube
to the
main frame
using 2
bolts (a)
and 2
flat
washers (b)
.
C Attach the
rear stabilizer
tube
to the
main frame
using 2
bolts (a)
and 2
flat
washers (b)
.
BOLT (A)
40 mm
Qty: 4
FLAT WASHER (B)
20 mm
Qty: 4
HARdWARE fOR STEp 1
:
BOLTS (A)
MAIN FRAME
FLAT
WASHERS (B)
REAR
STABILIZER
TUBE
FRONT STABILIZER TUBE
ASSEMBLY STEp 2
A
Open
hardware for step 2
.
B gently rest the
console mast
on the
rubber
landing pad
as shown.
C Attach
lead wire
to
console cable
. Pull
lead wire
through the
console mast
. After
pulling the lead wire through the mast, the top of
the
console cable
should be located at the
top of the mast.
D Rotate
folding handle
counterclockwise until
loose. Place the
console mast
into the
main
frame
as shown. Attach the
console mast
to
the
main frame
using 1
bolt (d)
.
E
Lift
console mast
upwards until
folding
handle
clicks into place and the
console
mast
is secured in the upright position.
F
Rotate
folding handle
clockwise until tight.
The folding handle may need to be loosened to
engage locking mechanism before tightening.
BOLT (D)
65 mm
Qty: 1
HARdWARE fOR STEp 2
:
MAIN FRAME
BOLT (D)
CONSOLE MAST
LEAD WIRE
CONSOLE CABLE
FOLDING
HANDLE
RUBBER LANDING PAD
NOTE: Feed the console cable into the
bottom of the console mast by hand before
pulling it through using the lead wire. Make
sure the console cable is pulled all the way
through so it will not get pinched when the
console mast is folded.
ce11-OM-rev2_4.indd 10-11
8/15/11 2:13 PM
