Page 1 of 18
SPECIFICATIONS
Temperature Controller:
Model TEC-9400, 1/16 DIN Dual Display with PID Auto-tuning
Sensor Input:
Type “J”, type “K” thermocouple or RTD, dependent on model ordered
(Alternative inputs available for special order)
Note:
Connector body colors are as follow:
Type “J” T/C: Black
Type “K” T/C: Yellow
RTD: White
Power Cord/voltage Input:
120VAC or 240VAC (dependent on model ordered) –
Check rear label for indentification
Heater Output:
12A max for 1-zone consoles
6A max per zone for 2-zone consoles
4A max per zone for 3-zone consoles
3A max per zone for 4-zone consoles
Output Device:
Solid State Relay
Main Power Switch:
Located on front panel
Fuse Main Power:
See replacement parts list (located inside power inlet module)
Fuse Control Power:
See replacement parts list (located on back panel)
WARNINGS
1. Air vents located on top and bottom of console must not be blocked! To prevent an overheating condition
the internal components must remain as close to room temperature (75ºF / 24ºC) as possible.
2. Dangerous voltage capable of causing injury or death is present within this console. Power to all
equipment must be disconnected before installation or beginning any troubleshooting procedures. Heater
output wiring and component replacement must be made by qualified personnel only.
3. To minimize the possibility of fire or shock, do not expose this console to rain or excessive moisture.
4. Do not use this console in areas where hazardous conditions exist such as excessive shock, vibration,
dirt, corrosive gases, oil or where explosive gases or vapors are present.
5. It is strongly recommended that a process should incorporate a Limit Control like a Tempco TEC-901
which will shut down the equipment at a preset process condition in order to avoid possible damage to
products or systems.
WIRING
(For safety, disconnect all power sources prior to wiring)
1. Attach the leads from your type thermocouple to the mini-plug provided. Take care to note the correct
polarity. The red lead is (-) negative.
2. The heater output current is sourced directly through the line cord. The rear console output receptacle and
mating Hubbell plug provides live controlled power for direct connection to your heater(s). Connect one lead
from your heater to one prong of the Hubbell plug (not ground). Connect the other lead from your heater to
the other prong. Connect heater ground (if applicable) to the ground connection (G) on the plug.
