TEMA TELECOMUNICAZIONI SRL
Doorphone AA-560
MAS-AA560-REV04EN
Page 25 of 65
8.3.2. Connecting the system expansion AA-539K
Once that the bottom rear plastic box of the
system is arranged in the wall, take the front
panel with the electronic board, insert the
two transparent plastic pins present on frame
into the appropriate holes on the wall box
and get ready to connect the wires to the
terminal blocks. Make sure that all cables,
including LAN, have not yet been powered
before connecting them to the card. These
operations must be performed by a
specialized technician. Take the cables that
have been prepared by one of the outgoing
access on the base system and start
connecting. Remove, connect, and replace
the terminals according to the connections to
be made. To make the connections do not
remove the system board from the front
panel but just remove the insertion
connectors.
H
jumper for internal heating circuit
L
jumper for backlighting circuit
FC
polarized connector for connection of the
expansion coming from AA-560 system
TBE3
terminals block for the Twilight service keys
backlighting when controlled by the relay 2 of
the AA-560 base system and redistribution of
the command to the eventually AA-539R
expansions present in the plant
Inserting legend card
To extract/insert the front legend card just
"pull" the block of the upper card held
pressed by springs on the front of the system
on the points indicated in the drawing with
the circle and the cross head screw (not to
unscrew) and extract or insert the card
extract from the top possibly with the help of
tweezers.
After inserting the personalized card, verify
the correct positioning looking from the front
of the transparent block.
For details of the connection of the signals on
terminal block TBE3, see section 0
