TEMA TELECOMUNICAZIONI
AD630S/630SA VoIP SIP 30W / PoE Horn
MAS-AD630S-REV00-Programming manual
Page 8 of 24
1.5. General settings
In this section it is possible to program general-purpose parameters, such as call duration, audio volume, tones,
ring and so on:
•
Communication duration
: once in connection with the extension, the call is still cut down after the set time.
•
Call attempt duration:
establishes how long the internal call attempt should last, in seconds (if the called
number rings but does not answer).
•
Response time:
when the AD630S is called, it answers after the set time. If it is 0, it answers immediately, if
999 it never answers.
•
Connection code:
when the device receives an incoming call, if this field is programmed, the audio is not
connected until the user enters the correct code.
•
Monitor code:
as in the previous case, in the case of incoming calls the audio is not activated if this code is
not entered, but unlike the previous parameter it allows the connection of the microphone audio only
("monitor" function, it is possible to only listen to the audio near the horn).
•
Registration code:
if this code is present, when the device receives an incoming call, it does not connect
the voice line but waits for the user to enter this code. If correct, the system starts recording the caller's
message which will be played when the phone call is hung up. It is possible to abort the registration by
typing '**'.
•
Push to talk:
allows you to enable the microphone only after pressing a button connected to the
programmed input
•
Communication volume:
sets the volume of the audio played to the external user. Possible values range
from 0 (very weak) to 9 (very strong).
•
Microphone sensitivity:
sets the sensitivity of the microphone and consequently the volume of the audio
reproduced towards the user within the company. Possible values range from 0 (very weak) to 9 (very
strong).
•
Ring type
: select the type of ring for incoming calls
•
Ringtone volume:
sets the volume of the ringtone sound emitted by the horn for incoming calls. Possible
values range from 0 (silent ringing) to 9 (very loud).
•
Signal tones / Tone volume
: it is possible to give signal tones to the external user (key press, call in
progress, end call), set the volume of any signal tones issued. Possible values range from 0 (very weak) to
9 (very strong).
•
Echo Limiter threshold:
this parameter indicates the audio level above which the voice exchange between
the caller and the callee can be carried out. Leave the default value.
•
Announcement code:
in communication, if you enter this code followed by a number from 1 to 9, one of the
9 pre-recorded announcement messages is played.
