TEMA TELECOMUNICAZIONI
IP PoE Multicast Encoder
AD615/S
MAS-AD615-S-REV00EN
Page 12 of 23
7. INSTALLATION
Position, connect and operate AD615/S is very simple.
7.1.
Mounting and System positioning
Simply place AD615/S on a table or shelf after applying the rubber anti-slip adhesive feet. Alternatively, if desired, it
is possible to screw to the bottom of the system the practical accessory adapter for DIN rail using only the 2.5MA
cross-head screws and washers supplied. Otherwise fix to the wall using the side fins with fastening eyelets and
screw anchors with screws provided. Warning: the side flaps can be opened only once to avoid their weakening.
7.2.
Connection
The connection must be carried out by qualified technical personnel, operate without power, strictly follow the
specifications of voltage and current levels indicated in the figure.
4-pin removable terminal block
+Vout
Terminal block from which it is possible to withdraw unregulated power supply, POSITIVE
GND
Terminal block from which it is possible to withdraw unregulated power supply, NEGATIVE
A
Terminal block to power the system, irrelevant polarity
C
Terminal block to power the system, irrelevant polarity
RJ45 LAN Port
AD615/S requires a LAN cable to connect to the network. If the port cable has also PoE, it will not be necessary to
supply the module with other power sources (Recommended solution).
At the "+Vout" output there is a + 12Vdc voltage when the device is powered via PoE, otherwise, at
this output the voltage will be the same as at the terminals A-C. The use of "+Vout" is permitted as
long as it is not exceeded a maximum 200mA current consumption and the load has a protection on
the input current. Improper use of this output will permanently damage the unit.
Devices powered via PoE (Power over Ethernet) may only be connected with cables coming from
inside the building, they are not allowed connections to LAN cables coming from outside the
building.
