Installing a new battery pack
1.
Hold the new battery pack over the battery
compartment, making sure the Telxon label is
facing you and the exposed battery contacts are
facing down. See Figure 4.
2.
Insert the bottom end of the battery pack (with
the exposed contacts) into the compartment first
and then lower the opposite end.
3.
Replace the battery door.
Replacing the alkaline battery
A 9-volt alkaline battery may be
used in non-radio versions of the
PTC-960RL, but for optimal perform-
ance, Telxon recommends using a
rechargeable nickel-cadmium battery
pack.
If your PTC contains a 9-volt alkaline battery, it is
held in place by a foam block and connected to the
PTC via a 9-volt battery cable.
Removing the alkaline battery
1.
Follow Steps 1 through 4 under “Removing the
battery pack” on
2.
Remove the battery from the foam block; then
unsnap the battery cable.
Battery pack ribbon
Exposed battery contacts
Figure 4. Replacing the nickel-cadmium battery pack
Nickel-cadmium battery pack
32
