56034002 1/9/2006
iii
© 2006 Telular Corporation
NOTICES
ABOUT THIS MANUAL
This manual assumes that you have basic security system installation skills such as
measuring voltages, stripping wire, properly connecting wires together, connecting wires to
terminals, and checking phone lines. It also assumes that you have a familiarity with the
proper installation and programming tasks related to various control communicator panels.
The material and instructions covered in this manual have been carefully checked for
accuracy and are presumed to be reliable. However, Telular assumes no responsibility for
inaccuracies and reserves the right to modify and revise this manual without notice.
It is our goal at Telular to always supply accurate and reliable documentation. If a
discrepancy is found in this documentation, please mail or fax a photocopy of the corrected
material to:
Telular Security Products
Technical Services Department
420 Thornton Road, Suite 109
Lithia Springs, GA 30122
Fax: 678-945-1651
© 2006 Telular Corporation. Lithia Springs, GA U.S.A. All rights reserved.
FCC NOTICES
EXPOSURE TO RADIO FREQUENCY ENERGY
In 1991, the Institute of Electrical and Electronics Engineers (IEEE), and in 1992, the American National
Standards Institute (ANSI), updated the 1982 ANSI Standard for safety levels with respect to human
exposure to RF energy. Over 120 scientists, engineers and physicians from universities, government health
agencies and industry, after reviewing the available body of research, developed this updated Standard. In
March 1993, the U.S. Federal Communications Commission (FCC) proposed the adoption of this updated
Standard.
The design of your Telular
Telguard
complies with this updated Standard. Of course, if you want to limit RF
exposure even further than the updated ANSI Standard, you may choose to install the unit in a manner that
locates its antenna at an even greater distance from the general public than is recommended as a minimum
by the standard.
To insure compliance with the standard, when selecting a mounting location for your
Telguard
do not mount
it (or its associated antenna) in an area where the general public could reasonably be within 8 inches (20
centimeters) of the antenna.
EFFICIENT OPERATION
Do not operate your Telular product when holding the antenna. Be sure to mount the unit such that its
antenna is a minimum of eight (8) inches (20 centimeters) is maintained from the general public.
For the best service quality, keep the antenna free from obstructions and point the antenna straight up.
