WE310F5-I/P EVB Hardware User Guide
1VV0301663
Rev.1
Page 13 of 20
2020-08-10
PB2 is connected only to PL605-1 to be externally wired to any desired GPIO pin on any other
connector’s header.
RESET button to use as an active low HW Reset pin press and release it to unconditionally
reset the module.
Module ON/OFF switchFigure 6:, allows to turn on or off the module.
9) RUN/PROGRAM switch
The slide switch located on the left side of following figure, allows to run or program the
module.
This switch must be controlled with the module off.
Figure 7: RUN/PROGRAM Switch
RUN: Normal operate mode
PROGRAM: Allow to update firmware through UART0.
13), 14), 15) USB 2.0 and UART
The WE310F5-I/P interface has one USB port and two UART ports as shown in the figure
below:Figure 8:
Two UART: one 2-wires UART0 and one 4-wires high speed UART1 port. Both ports have an
independent FTDI chipset to translate the UART to USB.
Figure 8: USB and UART Ports
17), 18) EVB power configuration for measuring current consumption (PL202 –
PL204)
The power configuration jumper position and the description are shown below:
Содержание WE310F5-I
Страница 1: ...WE310F5 I P EVB Hardware User Guide 1VV0301663 Rev 1 2020 08 10 ...
Страница 20: ......
