Telit Wireless Solutions WE310F5-I, Руководство пользователя по оборудованию

Страница: 12 / 20

WE310F5-I/P EVB Hardware User Guide
1VV0301663 Rev.1 Page 12 of 20 2020-08-10
Connect here the Wireless LAN Dual Band Antenna T-AT9552 to use the Wi-Fi/BLE
capabilities of the WE310F5-P
2) WE310F5-P module:
This is the Telit WE310F5-P Wi-Fi/BLE module.
3) GPIO alternative function PL302-PL305
In the following figure jumper PL302-305 allows to use GPIO as alternative function by means
of the proper jumper configuration.
Alternative function pads can be internally controlled by WE310F5 firmware and act according
to the implementation.
I2C function: Place jumpers on PL302 1-2, PL303 1-2
SDIO function: Place jumpers on PL302 2-3, PL303 2-3, PL304 2-3
GPIO function: Place jumpers on PL304 1-2, PL305 1-2
Figure 5: GPIO Alternative Function PL302-305
4), 5), 6), 10) Module ON/OFF/RESET/PB switch and button
The slide switch located on the left side of figure belowFigure 6:, allows to turn on or off the
module.
The EVB has three SMD push buttons as shown in the following figure:
Figure 6: Module ON/OFF/RESET and PB1-PB2 (PL605)
PB1 is connected only to PL605-3 to be externally wired to any desired GPIO pin on any other
connector’s header.