WE310F5-I/P EVB Hardware User Guide
1VV0301663
Rev.1
Page 15 of 20
2020-08-10
19) SWD debug connector
The SWD comes out with a 4pin connector in our board, the pin description is shown in the
figure below:
Figure 11: SWD Connector
To use SWD by using standard JTAG debugger:
•
Connect SWD_DATA to JTAG_TMS.
•
Connect SWD_CLK to JTAG_TCK.
•
Connect 3V3 and GND to respective pins.
11), 22) LEDs and GPIOs (PL606)
The WE310F5-I/P EVB has three different LED’s on the left part shown in the figure below:
each LED indicates a specific status:
LED Red indicates 3V3 voltage ON.
LED Yellow is custom LED:
connected only to PL606-5 to be externally wired to any desired
GPIO pin on any other connector’s header.
LED Green is custom LED: connected only to PL606-7 to be externally wired to any desired
GPIO pin on any other connector’s header.
The right part shown in Figure 12:, gives you the possibility to manually handle or monitoring
GPIOs and ADC/PWM.
Figure 12: LEDs and GPIOs (PL606)
Содержание WE310F5-I
Страница 1: ...WE310F5 I P EVB Hardware User Guide 1VV0301663 Rev 1 2020 08 10 ...
Страница 20: ......
