Telit Wireless Solutions SC872-A, Руководство пользователя

Страница: 48 / 53

SC872-A Product User Guide Safety Recommendations
1VV0301202 Rev. 6 Page 48 of 53 2018-12-21
PLEASE READ CAREFULLY
Be sure that the use of this product is allowed in the country and in the environment required.
The use of this product may be dangerous and must be avoided in the following areas:
•
Where it can interfere with other electronic devices in environments such as hospitals,
airports, aircraft, etc.
•
Where there is risk of explosion such as gasoline stations, oil refineries, etc.
It is the responsibility of the user to enforce the country regulations and specific environmental
regulations.
Do not disassemble the product. Evidence of tampering will invalidate the warranty.
Telit recommends following the instructions in product user guides for correct installation of the
product:
•
The product must be supplied with a stabilized voltage source and all wiring must
conform to security and fire prevention regulations.
•
The product must be handled with care, avoiding any contact with the pins because
electrostatic discharges may damage the product itself.
Since the modules are intended to be built-in, the system integrator is responsible for the
functioning of the final product; therefore, care must be taken with components external to the
module, as well as for any project or installation issue. Should there be any doubt, please refer
to the technical documentation and the regulations in force. The integrator must take adequate
precautions to avoid electrical, mechanical, and fire hazards.
Non-antenna modules must be equipped with a proper antenna with specific characteristics.
The European Community provides some Directives for electronic equipment introduced on the
market. All the relevant information is available on the European Community website:
http://ec.europa.eu/enterprise/sectors/rtte/documents/
The text of the Directive 99/05 regarding telecommunication equipment is available, while the
applicable Directives (Low Voltage and EMC) are available at:
http://ec.europa.eu/enterprise/sectors/electrical/
The power supply used shall comply the clause 2.5 (Limited power sources) of the EN 60950-1
standard and the module shall be mounted on a PCB which complies with V-0 flammability
class.
Since the module must be built-in to a system, it is intended only for installation in a
RESTRICTED ACCESS LOCATION. Therefore, the system integrator must provide an
enclosure which protects against fire, electrical shock, and mechanical shock in accordance
with relevant standards.
Caution – Risk of explosion if Battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions
15 SAFETY RECOMMENDATIONS